CpG Islands Track Settings
 
CpG Islands (Islands < 300 Bases are Light Green)   (All Expression and Regulation tracks)

Display mode:       Reset to defaults
List subtracks: only selected/visible    all  
pack
 CpG Islands  CpG Islands (Islands < 300 Bases are Light Green)   Schema 
pack
 Unmasked CpG  CpG Islands on All Sequence (Islands < 300 Bases are Light Green)   Schema 

Description

This track shows the CpG annotations on the 10 Jan 2019 Strigops habroptila/GCA_004011185.1_bStrHab1_v1.h genome assembly.

CpG islands are associated with genes, particularly housekeeping genes, in vertebrates. CpG islands are typically common near transcription start sites and may be associated with promoter regions. Normally a C (cytosine) base followed immediately by a G (guanine) base (a CpG) is rare in vertebrate DNA because the Cs in such an arrangement tend to be methylated. This methylation helps distinguish the newly synthesized DNA strand from the parent strand, which aids in the final stages of DNA proofreading after duplication. However, over evolutionary time, methylated Cs tend to turn into Ts because of spontaneous deamination. The result is that CpGs are relatively rare unless there is selective pressure to keep them or a region is not methylated for some other reason, perhaps having to do with the regulation of gene expression. CpG islands are regions where CpGs are present at significantly higher levels than is typical for the genome as a whole.

The unmasked version of the track displays potential CpG islands that exist in repeat regions and would otherwise not be visible in the repeat masked version.

Methods

CpG islands were predicted by searching the sequence one base at a time, scoring each dinucleotide (+17 for CG and -1 for others) and identifying maximally scoring segments. Each segment was then evaluated for the following criteria:

  • GC content of 50% or greater
  • length greater than 200 bp
  • ratio greater than 0.6 of observed number of CG dinucleotides to the expected number on the basis of the number of Gs and Cs in the segment

The entire genome sequence, masking areas included, was used for the construction of the track Unmasked CpG. The track CpG Islands is constructed on the sequence after all masked sequence is removed.

The CpG count is the number of CG dinucleotides in the island. The Percentage CpG is the ratio of CpG nucleotide bases (twice the CpG count) to the length. The ratio of observed to expected CpG is calculated according to the formula (cited in Gardiner-Garden et al. (1987)):

    Obs/Exp CpG = Number of CpG * N / (Number of C * Number of G)
where N = length of sequence.

CpG item counts

  • masked sequence: item count: 4,787 bases covered: 3,391,955
  • unmasked sequence: item count: 5,487 bases covered: 4,873,776

Credits

This track was generated using a modification of a program developed by G. Miklem and L. Hillier (unpublished).

References

Gardiner-Garden M, Frommer M. CpG islands in vertebrate genomes. J Mol Biol. 1987 Jul 20;196(2):261-82. PMID: 3656447